Settings
In the app, various settings can be adjusted to your preference. Once you have installed the E-Pressure, you can still make adjustments in the settings. To do this, go to the E-Pressure module in the app and click on settings at the bottom left.
Pressure
- Vehicle 1 or 2
Here you can enter the lower and upper tyre pressure limits, per connected vehicle and per axle. You can do this with the slider or by typing in the white box. Please note that the pressure can increase by approx. 0.5 bar (7.25 PSI) during driving.
Take the manufacturer’s recommended tyre pressure as a starting point. Then set the minimum and maximum (recommended 0.5 bar above or below the recommended pressure).
If you have more vehicles coupled (e.g. a motorhome and a trailer), you will see an arrow at the bottom. From the centre of the screen, swipe up or down to see the other vehicle’s settings.
Temperature
- Vehicle 1 of 2
Here you can enter the maximum tyre temperature for each connected vehicle. You can do this with the slider or by typing in the white box.
Please note that the temperature of the tyres can rise to 25 degrees Celsius (77 Fahrenheit) above the ambient temperature while driving.
If you have connected more vehicles, you will see an arrow at the bottom. From the centre of the screen, swipe up or down to see the other vehicle’s settings.
General
- Notifications
Here you can specify the type of notifications you wish to receive. - Preferences
Here you indicate whether you want to see the information in Bar/Celsius or PSI/Fahrenheit. - Reinstall
If you want to reinstall the sensors, you do not need to scan the QR code. Here you simply click Unlink all sensors and install again and once again go through the calibration process step by step.
Notifications
You can set the notifications for each module. There are 3 types of alerts that warn you if the minimum or maximum values you set for this particular module are exceeded:
- Sound: a sound is played.
- Vibrate: the phone will vibrate.
- Pop-up: A message appears on the screen, even if, for example, you have your navigation switched on.
For each type of alert you can switch it on or off by means of the slider to the right of the alert type.
Notification is not correct
Do you get a message when you think everything is fine? Then it may be that the minimum or maximum values in the settings are not correct. Check these in the E-Pressure settings and adjust if necessary.
Please note that during driving or in warm (or cold) conditions, the tyre pressure and temperature may be higher than expected. Take this into account when setting the minimum and maximum values.