
Settings
In the app, various settings can be adjusted to your preference. You can still make adjustments in the settings for each linked E-Switch as well as in the general settings.
Settings per linked E-Switch
Go to the E-Switch and click on the specific module you want to change. What you can adjust:
- Name: give each connected E-Switch its unique name.
General E-Switch settings
When you have installed the E-Switches, you can still make adjustments in the settings. To do this, go to the E-Switches module in the app and click on settings at the bottom left. Here you can adjust the general settings that apply to all connected E-Switches:
- Notifications
Here you can specify the type of notifications you wish to receive. Please note that you will only receive notifications if you are driving for at least 10 seconds. When standing still, only the colour of the block will turn orange. -
Remove all sensors
If you want to reinstall the sensors, you do not need to scan the QR code. Simply click on Unlink en install again. You then have to go through the calibration process again step by step for each paired sensor.
Notifications
You can set the notifications for all connected E-Switches. There are 3 types of alerts that warn you if the component on which you have mounted the E-Switch is open:
- Sound: a sound is played.
NOTE: An audible alarm will be given only while driving. At standstill, only the colour of the specific module can tell whether something is open or closed. - Vibrate: the phone will vibrate.
- Notification: a notification will appear on the screen, even if, for example, you have your navigation switched on.
For each type of alert you can switch it on or off by means of the slider to the right of the alert type.
Notification is not correct
Do you get a message when you think everything is fine? Then it may be that the two parts are mounted too far apart or too close together. Check that the distance between the 2 parts is not more than 5mm when the part is closed or more than 5mm when it is open.
Also note how the parts are mounted in relation to each other. Check the mounting instructions for what is and is not good.